Seamless. Sanitary Serious
A solid-color polyaspartic system without flake — engineered for commercial and light-industrial slabs that need a hard, easy-to-clean surface. Single-color topcoat, seamless finish, optional anti-slip aggregate or line striping.
Layer by layer.
Every Blue-Chip system is built from the slab up. Here's what goes down, in what order, and how thick each layer ends up.
The datasheet.
Every number we put in writing on a quote. Cure times are typical — weather, substrate, and temperature can shift them ±20%.
Prep is where
floors pass or fail.
A floor is only as good as what's under it. No acid etch, no shortcuts, no 'good enough.' These steps run every job.
Diamond grind to CSP-3 profile
Moisture test (calcium chloride) on slabs > 5 yrs old
Polyurea joint + crack repair
Solvent wash for chem-exposed zones
Where this system shines.
This system is engineered for a specific kind of space. Here's where we'd steer you toward it.
Care & cleaning.
Polyaspartic floors don't need sealing or waxing — just reasonable care. Here's the short list.
- 01Daily mop with pH-neutral cleaner
- 02Auto-scrubber compatible after 7 days
- 03Chemical splashes — rinse within shift
- 04Line-paint or caution striping applied with compatible urethane paints.
Completed installations.
Photos from real Blue-Chip jobs using this exact system.
Questions we get
about this system.
Still stuck? See the full FAQ or send us a message.
Ready for a floor
that outlasts your lease?
Tell us about your space — square footage, condition, what you want the finish to feel like. We'll come measure, map the cracks, and hand you a flat quote with no surprises.